Fitting Your Car Tyre – A Step By Step Guide to The Entire process

Tyres are an essential component of your vehicle. But extended contact with rough surfaces at high speeds can cause them to wear quite often. It means that regular maintenance of the tyres is essential for them to last longer.

 

However, there can be times when a tyre may wear down or go flat on the road. These situations are uncalled for and may be disturbing. In these situations, you should go for tyre fitting in Peterborough. You may face problems if you are unaware of the proper way in which it is done. Therefore, it is recommended to have an appropriate idea of how to change tyres efficiently.

How To Mount Your Tyres?

A unique tool is essential to change tyres. The best way to go on with removing and mounting new tyres is by using a tyre changer. Without a mounting arm and a bead breaker, it is not possible to change a tyre.

1. Process Of Removing The Tyre

An old tyre rubber needs to be removed first when you go for Tyre Fitting Peterborough. Following are the steps in which it is done.

  • Car is first jacked up to make it easier to detach the wheel from the axle.

  • Tyre valve is unscrewed in the next step to release the air.

  • The mounting machine is used to detach tyre wall from the rim with the help of a bead breaker.

  • A tyre is turned, and the process repeated.

  • The dismantling step makes sure that the tyre bead, inner tyre ring is thoroughly pressed over the hump of the rim.

  • After that, a mounting machine is fastened to the rim which removes weight balances.

  • A mounting lever is then used to position the inner ring of a tyre over the mounting arm.

  • A Mounting machine is then rotated which pulls off tyre from the rim.

2. Process Of Tyre Mounting

Following are the steps involved when you opt for mounting Tyres in Peterborough

  • The first thing to do is coat tyre beads on the interior and exterior with a tyre mounting paste or grease, which makes it easier to pull on.

  • Rim is then clamped on the mounting machine followed by utilising mounting arm which helps position the lower tyre flank on the upper edge of the rim.

  • The mounting machine is rotated to pull on a tyre.

  • The process is repeated for the upper tyre flank.

Garages such as Forza tyres provide you with various services along with fitting tyres such as wheel alignment, puncture repairs and reseals. Whenever you face any problems with your existing tyre, you should opt for Tyre Fitting in Peterborough before it is too late.

Before mounting the tyre, it is essential to check the exact size and age of the tyre. The vehicle may face disturbances in case the tyre size is not right. Not only that but to have the best driving experience, you need to be cautious when choosing the tyre. The clearer the grooves and ribs, the better the grip it will have on the surface of the road.

Leave a Reply

Your email address will not be published. Required fields are marked *