Know When to Opt for a Suspension Repair from the Condition of Your Car Tyres

When talking about suspension, people often talk about springs, shock absorbers and dampers. What we tend to forget is that a tyre is also a part of the suspension system.

With this information in mind, you can easily discern whether there are issues with the suspension system, as it will reflect on your car’s tyres.

Signs That Your Suspension System is Defective

  • An unnecessarily bumpy ride

Your car repeatedly tackles bumps and uneven roads. This can happen due to the following reasons:

  • Dysfunctional struts and dampers.

  • Hydraulic oil inside the dampers and struts may leak out, due to rusting of the damper casing.

  • Loss of stiffness of springs.

Shock absorbing springs can lose their stiffness with time. As a result of which the springs will fail to counterbalance the upward forces that arise out of jerks and vibrations.

  • Erosion of tyre tread

    • Tyres treads erode unevenly.

    • Rapid tyre abrasion- tyres tread erodes faster than usual.

    • Damages at localized spots because of excess stress on the wheels

If you notice any of these above signs, visit a professional garage for a suspension repair in Pickering or anywhere else in the UK. Getting your tyres re-treaded or replacing them will also be necessary after repairing your suspension considering that the faulty suspension has already damaged your tyres by this time.

Remember that maintaining proper tyre inflation will keep away a lot of issues with your suspension system. You must check the tyre pressure on a routine basis. Having a tyre pressure gauge will help you with this process. A tyre pressure gauge is a handy device, and it’s not very expensive either.

Steps For Checking Your Car’s Tyre Pressure

  1. Look for a manufacturer’s sticker in your car’s door, which will have the correct recommended pressure for your car tyres. This number is the cold tyre inflation pressure, which is the lowest PSI your car tyres must have. [PSI – pound per square inch.]

  2. Remove the valve stem cap form the tyre nozzle.

  3. Push the air pressure gauge evenly onto the valve stem and read the values that appear.

  4. This is a very critical step where you must use your judgement. If the reading is the same as manufacturer’s PSI specification, you may want to make no further adjustments. However, considering that the number given by your car’s manufacturer is the lowest limit, you may add some pressure if your tyre inflation is close to the given value. A higher tyre pressure will result in better fuel efficiency. But do not over inflate. It will cause uneven tyre wear, longer braking distances and deteriorating drive-ability.

As mentioned earlier, any problems with your suspension system will eventually damage your car’s tyre. So, just fixing the suspension will not be enough and you will need to replace the worn out tyres in Pickering. Visit ADD Tyres and Exhausts for purchasing new tyres. It also provides other common car services like wheel alignment, wheel balancing, etc. other than suspension repairing services.

Leave a Reply

Your email address will not be published. Required fields are marked *